Label - PCT Reactor Foam Dye Marker - 251107
Applies to Reactor Foam Marker | Foam Marker Dye
Document contents
Text extracted from the source document for accessibility and reference. Always consult the original product label above for the authoritative version.
*Reactor is a registered trademark of PCT INTERNATIONAL PTY LTD (PCT Holdings Pty Ltd )
READ SAFETY DIRECTIONS BEFORE OPENING OR USING
FOAM DYE FOAM MARKER
ACTIVE CONSTITUENT: Blend of Surfactants
FOAM MARKER FOR USE WITH AGRICULTURAL SPRAYING
CONTENTS 5 LITRES
PCT HOLDINGS Pty Ltd
Unit 1/74 Murdoch Circuit
PCT Reactor Foam Marker 5/29/06 1:52 PM Page 1
DIRECTIONS FOR USE
NOT TO BE USED FOR ANY PURPOSE, OR IN ANY MANNER, CONTRARY TO THIS LABEL UNLESS AUTHORISED UNDER APPROPRIATE LEGISLATION.
| SITUATION | RATE | CRITICAL COMMENTS |
|---|---|---|
| Pastures, broadacre crops & Direct drilling | 1 part Foam Marker to 100 parts water | Use at this rate for boom spray foam marking in foam generators. Foam should last approximately 2 hours on ground in good weather conditions. However, life span will be affected by hot, dry conditions (over 35 degrees celcius) or where the water is cold or “hard”. |
| 1 part Foam Marker to 50 parts water | Use at this rate if weather conditions are very hot and dry (above 35 degrees celcius) or where the water used is either cold (less than 10 degrees celcius) or hard (greater than 350 ppm Calcium Carbonate). |
GENERAL INSTRUCTIONS: PCT Reactor Foam Marker is a concentrated foam liquid for use through foam generating devices to identify broadacre spray swath width.
MIXING: Half fill foam tank with water. Add required amount of PCT Reactor Foam Marker. Place hose in tank below water line and top up to fill tank. Ensure that solution is thoroughly mixed.
PROTECTION OF WILDLIFE, FISH, CRUSTACEANS AND ENVIRONMENT: Do not contaminate ponds, streams, rivers or waterways with the chemical or used containers.
STORAGE AND DISPOSAL: KEEP OUT OF REACH OF CHILDREN Store in the closed, original container in a cool, well ventilated area. DO NOT store for prolonged periods in direct sunlight. Triple or preferably pressure rinse containers before disposal. Add rinsings to spray tank. DO NOT dispose of undiluted chemicals on site. Break, crush or puncture and bury empty containers in local authority landfill. If not available bury the containers below 500mm in a disposal pit specifically marked and set up for this purpose clear of waterways, vegetation and roots. Empty containers and product should not be burnt.
SAFETY DIRECTIONS: Avoid contact with eyes and skin. When using or preparing product for use, wear overalls, PVC/rubber gloves, goggles and safety shoes. After use and before eating, drinking or smoking wash hands.
FIRST AID: If poisoning occurs, contact a Doctor or Poisons Information Centre Phone Australia 13 11 26. If swallowed rinse mouth with water. Give several glasses of water to drink. If vomiting occurs, give more water to drink and seek medical advice. If in eyes, hold eyes open and flood with water for at least 15 minutes and see a doctor. If skin contact occurs, remove contaminated clothing and wash skin thoroughly with soap and water. If irritation occurs seek medical advice.
MATERIAL SAFETY DATA SHEET: For further information refer to the Material Safety Data Sheet (MSDS).
CONDITIONS OF SALE: “PCT Holdings Pty Ltd” (“PCT”) shall not be liable for any loss, injury, damage or death, whether consequential or otherwise whatsoever or howsoever arising whether through negligence or otherwise in connection with the sale, supply, use or application of this product. The supply of this product is on the express condition that the purchaser does not rely on PCT’s skill or judgement in purchasing or using the same and every person dealing with this product does so at his own risk absolutely. No representative of PCT has an authority to add to or alter these conditions.”
Batch No. Date of Manufacture
In an Emergency Dial 000 Police or Fire Brigade
[Barcode: 9 336152 000577]
PCT Reactor Foam Marker 5/29/06 1:52 PM Page 2